Digium have replaced TE110P with TE120P which utilizes Digium's VoiceBus™ technology, therefore this card is no longer being sold.

Go to the TE120P webpage.

The Wildcard TE110P brings a high-performance, cost-effective, and flexible single span togglable T1, E1, J1 interface to the Digium line-up of telephony interface devices. The TE110P is a single span, selectable T1 (24-channel), E1 (32-channel), or J1 (24-channel) card that supports all the functionality of our quad T1/E1/J1 card. This card supports both voice and data modes on its single span. For example, the card can support 12 channels dedicated to voice and 12 to data while passing all traffic through to the Asterisk Open Source PBX, which reliably routes the channels to their designated locations. This eliminates the need for an external router.

By utilizing TDMoE (TDM over Ethernet) technology, an exclusive Digium process, one can easily connect multiple PCs equipped with the TE110P and achieve voice quality on par with single PBX implementations. Scalability for this product is derived from adding multiple TE110Ps to each individual PC. Add addition cards as you need them for your expanding applications.

The TE110P supports industry standard telephony and data protocols, including both RBS and Primary Rate ISDN (PRI) protocol families for voice and PPP, Cisco HDLC, and Frame Relay data modes. The board drives both line-side and trunk-side interfaces, including call features.

Data Modes Cisco HDLC HDLC PPP Multilink PPP Frame Relay Voice Modes PRI CPE & PRI NET - NI1 / NI2 / EuroISDN / 4ESS (AT&T) / 5ESS (Lucent) / DMS100 E&M - Wink / Feature Group B / Feature Group D FXO & FXS - Ground Start / Loop Start / Loop Start with Disconnect Detect

Certifications Telecom: FCC Part 68 (TIA-968-A), IC CS-03, TBR4, TBR12, TBR13, AS/ACIF S038, AS/ACIF S016, HKTA 2028 Safety: UL/CSA 60950, IEC 60950, EN60950, AS/NZS 60950 Note: Finland, Norway and Sweden require that equipment using this product must be located in a Restricted Access Location (RAL). Emissions: EN55022 Class A, IEC 61000 TE110P Jumper Configurations The Wildcard TE110P can be configured to support T1 (24 Channel), E1 (32 Channel, and J1 (24 Channel) by changing the card's jumper settings, listed below. Jumper Settings: T1/J1 Jumper Settings — Jumper Off E1 Jumper Settings — Jumper On

Technical Data

Data Sheet (PDF)
Quick Install Guide for Asterisk™ & Zaptel (PDF)
Zaptel Configuration (PDF)
Zaptel PPP Guide
Zaptel HDLC Guide
Basic Configuration and Examples

If you have an ISDN connection from NTL then please ensure you request the ISDN 110 service as the TE110P will not work the NTL standard ISDN connection (ISDN 85).

More Information

Do you want to find out more about VoIP in general? Check out our VoIP FAQ

VoIPtalk ships products to any destination worldwide. View our Shipping & Returns policy for more information.

Are you interested in becoming a reseller of our products? Contact us now for more information.